Install the mounting brace.
American standard pedestal sink installation instructions.
Mark the sink height on the wall.
Dimensions of fixtures are nominal and may vary within the range of tolerances established by ansi standard a112 19 9.
Connect the basin to the wall.
Remove excess putty after installing drain on sink.
Two 2 x 8 50 x 203 mm wood braces to wall studs.
Check the manufacturer s instructions on your sink.
And extend a minimum of 12 305 mm to either side of.
Bottom of brace should be 26 1 2 673 mm up for floor.
Space supplies hot cold screwdriver.
Attach the mounting bracket.
Cut out part of the wallboard to reveal the studs.
These measurements are subject to change or cancellation.
Bolt pedestal to the floor.
Here s how to install it.
Some pedestal sinks require a support board behind the finished wall for extra strength.
No responsibility is assumed for use of superseded or voided pages.
Stops 1 5 8 41mm to either side of center.
Notch the studs for the support board with a jigsaw.
Following manufacturer s instructions install faucet and drain assembly not included.
Finished wall pedestal side section.