Apply Vinyl Lettering Windex

Spray the adhesive side of the decal with windex after or as you peel away the backing paper.

Apply vinyl lettering windex.

Such as metal glass plastic wood wall board etc. The ammonia interferes with the adhesive. If you have never applied vinyl die cut decals it is recommend to do a little research online. The vinyl will not stick as well to any oil or waxy surface.

How to apply vinyl lettering racing stripes vinyl stickers vinyl decals pinstripes and more. If you re applying the decal to glass do not use windex or other ammonia based cleaners. There are many youtube videos and websites that have great tutorials on how to apply vinyl die cut decals. Only remove the wax paper when you are ready to apply the decal to prevent dirt from getting on the adhesive surface.

Apply water to the back side of the. Use a little rubbing alcohol to clean the area where the decal will be applied. Wipe away the excess windex and let the decals take a set. Squeegee windex from under the decal beginning in the center and working outward.

Remove the wax paper. With some elbow grease the adhesive can be removed. Peel off the wax paper using a friend to help with bigger decals. They are all a little different but very helpful.

Peel the backing paper from the decal. Apply rubbing alcohol to remove any remaining oils or waxes from the vehicle s surface. Mild detergents or solvents can be used to remove wax grease tar etc. To apply a vinyl cut decal prepare the metal as above and wash with soap and water including new paint.

Final note the application of this vinyl decal requires a degree of dexterity and concentration. Do not use windex in an aerosol can. Vinyl can be applied to any smooth surface. Apply vinyl lettering to your surface lower the mask layer and using your squeegee press firmly at a 45 degree angle starting from the middle and going out.

If air bubbles occur puncture with a pin and smooth down. Whether you are applying a small decal such as a college sticker or parking permit or adhering a large rear window graphic choosing the right tools in the best weather conditions and taking plenty of time will assure effective decal application. Surface should be clean and dry before applying vinyl lettering. If there are larger areas with the adhesive we recommend spraying the area with windex and with a soft cloth that will not scratch the vinyl clean the area.

This is key and it s a good time to walk away from the car. Use the squeegee to squeeze out all the windex and air bubbles from underneath the decal.