Applying Vinyl Stripes

This is a quick look how to install vinyl body graphic rocker stripes on your car.

Applying vinyl stripes.

I show you how to install vinyl decals on a car using soapy water. Inspect your new vinyl decal for any shipping damages please do not fit decals that you think have an issue. The top layer of your graphic is the application tape premask. In this case please contact us we are here to help.

After cutting this vinyl decal with the cri. It s not hard but does take a little bit of time. The adhesive side of the vinyl faces downward. A step by step instruction video on how to apply pre cut racing stripes on your car.

The bottom layer is the release liner backing paper. Using a squeegee on a table press firmly over the whole decal assuring the pre mask transparent application tape is properly stuck to the vinyl decal. Tools needed to apply your racing stripes. After peeling off the backing paper place the sticker on a dry or wet surface depending on your personal preference.

Does vinyl need to breath. The middle layer is the vinyl decal. Water will only be needed on larger decals to ensure that the air bubbles can be pushed out from underneath the vinyl. You can seal.

Racing stripes manufactured using the 3m 1080 wrap series film featuring. There is a common misconception that vinyl needs to breath and that therefore you shouldn t apply any sealant. You may follow all of the instructions below. Just make sure area where installing is clean.

Vinyl on rough surfaces such as wood or stainless steel. Moreover besides making your vinyl last longer some sealants can also give a nice finishing touch as well. But you will not need to use water. Cutting vinyl with the cricut explore is very easy but weeding it and applying it to a surface can be confusing.

If you are applying 3 high or smaller lettering.